NV_PackMule
New member
- Joined
- Dec 8, 2017
- Messages
- 6
Bow: Diamond SB-1
Rest: Trophy Taker Smackdown Pro
Set up by pro shop
I paper tuned (at 10 ft) and the rest needed a lot of adjustment to get the arrow tip holes inside the fletching. I then nock tuned to get a little cleaner paper tears. I also put lipstick on the fletching to make sure I wasn't hitting the cables or rest housing while on the way out.
When I took it out to 20 and 30 yards I needed to move the sight's windage quite a bit and now the sight housing is about 1/3 blocked by the riser. I can see the pins fine, but this doesn't seem right.
I plan to go back to the shop this weekend, but wanted to see if anyone has any ideas.
As far as I can tell I'm not adding torque to the bow. Even if I draw back and grip with my thumb and index finger I get the same results.
Rest: Trophy Taker Smackdown Pro
Set up by pro shop
I paper tuned (at 10 ft) and the rest needed a lot of adjustment to get the arrow tip holes inside the fletching. I then nock tuned to get a little cleaner paper tears. I also put lipstick on the fletching to make sure I wasn't hitting the cables or rest housing while on the way out.
When I took it out to 20 and 30 yards I needed to move the sight's windage quite a bit and now the sight housing is about 1/3 blocked by the riser. I can see the pins fine, but this doesn't seem right.
I plan to go back to the shop this weekend, but wanted to see if anyone has any ideas.
As far as I can tell I'm not adding torque to the bow. Even if I draw back and grip with my thumb and index finger I get the same results.