Last night I set my center shot the best I could and this morning I was yoke tuning through paper with both bare shafts and fletched arrows. I started with a large left tear which I was able to completely get rid of after pressing the bow and twisting the yokes a couple of times. Once I got a perfect left and right I noticed that I now had a little nock high tear going on. Do you guys think that this is because by fixing the tear I through my timing off? Or because I was just getting tired and could have also been shooting at a downward angle. I made sure to twist both the top and bottom yoke each time. I also did not have a chance to throw it in the draw board yet. Anyone have suggestions, should I move my rest slightly? Also important to note I shot bareshaft and fletched at 10 yards and they were pretty much right next to each other. Should I leave it as is? Thanks in advance guys any suggestions would help.